400 Liters Fermenter Bioreactor Used ABEC Fermenter / Precision Stainless Reactor, 400 Liter (Approximately 105.66 gallons), 316L Stainless Steel, Vertical. Approximately 22" diameter x 60" straight side, dished top, dished bottom. Internal pressure rated 40 psi at -20 to 300 degrees...
400 Liters Fermenter Bioreactor
Used ABEC Fermenter / Precision Stainless Reactor, 400 Liter (Approximately 105.66 gallons), 316L Stainless Steel, Vertical. Approximately 22" diameter x 60" straight side, dished top, dished bottom. Internal pressure rated 40 psi at -20 to 300 degrees F. Designed for Full Vacuum at 15 psi. 304 Stainless steel dimple jacket pressure rated 60 psi at -20 to 300 degrees F. Designed for Full Vacuum at 15 psi. Bottom entering agitator, approximate 1-1/2" diameter shaft with 3-tier, 9" diameter (6) blade impellers, driven by a 5 HP, 3/60/230/460 volt, 1750 rpm motor with a 5.17:1 gearbox ratio. Openings top: (3) 2", (2) 3", (2) 1-1/2", (1) 4". Approximately 2" center bottom outlet. (4) Sidewall baffles. Mounted on (3) stainless steel legs. Nation Board# 5872, Serial#9377.
Our engineers can also produce any kinds of Fermenter Bioreactors as to the clients' requirements.
Agitation | Drive | DC motor, AC Gear motor, Top drive(mechanical seal driving) |
Range | 50~1000rpm ±1rpm | |
Impellers | Turbine impeller(SUS316L) Foam breaker (SUS316L) | |
Sensor | Magnetic Hall sensor | |
Control | Microprocessor based PID control | |
Materials& Finish | Vessel | Using 316L stainless steel it is polished mechanically and electrically |
Piping | 316L stainless steel prevent contamination and is polished | |
O-rings/Gaskets | silicon material is used for the O-ring and the EPDM is used for gasket | |
Sterilization | Built-in heater makers the in-situ sterilization for the vessel, head plate, filter, aeration pipe lines in 105℃~130℃temperature range automatically | |
Temperature | Range(℃) | From 3oC above the cooling water temperature to 80oC (accuracy±0.1 ℃) |
Sensor | RTD(Pt-100) | |
Control | The built-in heater cartridge raises and cooling water pulling downs the water temperature and water pump circulates the water inside of the jacket | |
Aeration | Sparger | Ring sparger (SUS 316L) |
Intel Filter | The cartridge type sterilizable pleated type 0.2um absolute filter specifications(option item) | |
Outer Filter | The same as internal filter specification(option item) | |
Control Range | Different vessel size and/or ordered specifications | |
Pressure Control | The back pressure is controlled manually or automatically | |
Control Unit | Panel | 8.5"Graphic Color LCD, Membrane keypad |
Communications | Memory stick,printer,computer with the RS-232C communications protocol | |
Controller Board | Microprocessor based integrated controller board is adopted to measure, control and display the fermentation system | |
Power Supply | 220V 50/60Hz,Single phase | |
Data Storage | pH, DO, Pressure,Temperature and Agitation speed |
• The stainless steel (SUS316L) is used to prevent contamination and rust.
• The water jacket system is adopted for precise temperature control.
• The sight glass makes to monitor the status of the media.
• The spare ports are installed on the head plate that the auxiliary sensors can be installed.
• The sensor ports are installed in the circumferential direction on the lower side of the vessel.
Model | Total Vol. (working Vol.) | Inner Dia. | Inner Heighta | Impeller Diameter | D/P | H:D |
D | H | P | ||||
SD-10 | 10L (7L) | 190 mm | 365 mm | 80 mm | 42% | 2 :1 |
SD-15 | 15L (10L) | 215 mm | 430 mm | 90 mm | 42% | 2 :1 |
SD-20 | 20L (14L) | 235 mm | 470 mm | 95 mm | 40% | 2 :1 |
SD-30 | 30L (20L) | 260 mm | 555 mm | 105 mm | 40% | 2 :1 |
SD-40 | 40L (30L) | 295 mm | 590 mm | 120 mm | 40% | 2 :1 |
SD-50 | 50L(40L) | 335 mm | 635 mm | 135 mm | 40% | 2 :1 |
Our Services
1. Installation: We will send our engineer to help you with the installation and guide you with usage.
2. We will ensure the success of installation and commission.
3. Working life of main equipments: 15 years
4. Potential problem: Degradation of strain.
5. Solutions: Optimization and renew, we will supply the new strain freely in two years, then our engineer will provide techniques for optimization and renew.
6. Plant visit: We will arrange to visit one of similar lines we implemented in China and expect your coming!
Contact with me for more informations
sale ( @ ) sentinaininc . com
Sentinain Technology has over 20 years experience in providing 400 liters fermenter bioreactor for you. As one of the leading manufacturers and suppliers in China, we are equipped with advanced equipment and technology. Please be free to get the low price equipment from our factory and check the quotation with us.